Discreet motion sensing for the ultimate smart home
100% Silent relay
No annoying 'Click'. The Motion Sensor 360 range uses a completely silent, solid state relay.
A subtle stylish sensor that protrudes less than 3.5mm from the ceiling.
So small it can be mounted in a business card. The visible front is just 49mm across.
Low voltage power, ideal for a broad range of control systems.
Our motion sensors use the latest digital sensors
Here at Faradite, design is everything, but, not at the compromise of functionality. During the design of the Motion Sensor 360 range we wanted to keep the profile to a minimum. The result, a high spec digital sensor that only protrudes 3.5mm from the ceiling.
The Motion Sensor 360 range introduces a robust, discrete and stylish option for your smart home.
Our connectors make for a speedy installation, simply strip the solid core wire and push into the connector
Simply insert the supplied tool or a small screwdriver to release the wire
To remove the sensor, simply pull the connector out of the motion sensor. It couldn't be simpler
The Fire IDR is specially made by Envirograf® to fire rate the Motion Sensor 360 range, according to BS476: Part 21 1987.The intumescent material expands in a fire, sealing the hole in the ceiling structure.
With the Fire IDR fitted, the Motion Sensor 360 has a 60 minute fire rating.
If you are installing the sensor in a fire rated ceiling then select the fire rated option and we will ship you the sensor and a Fire IDR.
To install the Faradite sensor, cut a 35mm hole using a suitable hole saw (40mm for fire rated). Fold the spring clips upwards and push through the hole.
12V - 24V DC @ 24V (3mA)
Digital Output (Motion)
0-10V Analog Output (Brightness)
Push fit screwless connector AWG 20- 24 suitable for CAT5 / CAT6 / CAT7.
RANGE / DETECTION AREA
Specified Range 5M / When mounted at a height of 3M, the sensor covers an ~8M diameter floor area. When mounted at 2.5M, it covers a floor area of 5.6M by 6.6M.
Ideal for CAT 5/6, simply strip the solid core wire and push into the connector
Ideal for CAT 7, simply strip the solid core wire and push into the connector
Ideal for stranded cable (e.g. Belden Cable), simply insert the supplied sim card remover tool before pushing the wire into the connector